Soft reboot when valid project detected on USB
Soft reboot when valid project detected on USB
This project has a thread that looks for a valid project on a connected USB. When a valid project is detected, it initiates a soft reboot when the timer reaches 100 seconds. The timer was put in to give an operator time to pull the USB out of the panel after it successfully loads. Warning: leaving the USB connected that contains a valid project will continuously reboot the panel every 100 seconds.
- Attachments
-
- UsbRebootAndLoad.zip
- (840.64 KiB) Downloaded 1459 times
Best Regards,
Kyle W. | Applications Engineer
Beijer Electronics, Inc.
Kyle W. | Applications Engineer
Beijer Electronics, Inc.
Re: Soft reboot when valid project detected on USB
Locked
Best regards,
Christopher
(801) 708-6690
Technical Support
Contact Us
Beijer Electronics AB
http://www.beijerelectronics.us
Christopher
(801) 708-6690
Technical Support
Contact Us
Beijer Electronics AB
http://www.beijerelectronics.us