Communication protocol setting by scripting

A forum devoted to the discussion of all topics having to do with scripting and other advanced programming using iX Developer.
Post Reply
Sergei Troizky
Posts: 22
Joined: Mon Jun 13, 2016 4:03 pm

Communication protocol setting by scripting

Post by Sergei Troizky »

I need to change the setting on the picture by executing a script.
Is this possible? If yes, any idea how?
Attachments
FINS Source.jpg
FINS Source.jpg (94.24 KiB) Viewed 464 times

Artaxs
Posts: 9
Joined: Tue Nov 06, 2012 7:02 am
Location: Switzerland

Re: Communication protocol setting by scripting

Post by Artaxs »

Hi Sergei

At the moment, there is no (easy) way to do so. But....
I did a similar thing by changing the config file of the driver via script to change IP addresses of controllers.

I'm right now not in the office (like many others :geek: ), so I can't post sample code here. But you might give it a try. Have a look at the compiled project and check if you could find a config file.
By the way: after the change, there is a reboot needed. But this can also be achieved by script.

Sergei Troizky
Posts: 22
Joined: Mon Jun 13, 2016 4:03 pm

Re: Communication protocol setting by scripting

Post by Sergei Troizky »

The question remains open.
Any help will be appreciated.

Post Reply