Do-more PLC with a iX T7A communication

Discussion of configuring and troubleshooting communication to PLC's or other devices using iX Developer.
Post Reply
mike.b
Posts: 1
Joined: Wed Sep 21, 2016 11:27 am

Do-more PLC with a iX T7A communication

Post by mike.b »

Hello

Just looking to see if anyone has ever successfully setup communication from a Beijer iX T7A to an Automation Direct PLC such as the Do-more H2-DM1E.

In reviewing the list of possible controllers I am assuming I would have to select a Modicon Modbus Slave as automation direct is not listed.

I have setup several products using modbus communication but never a Beijer product.

In my testing I am continually getting a "no connection" alarm. All of my usual settings in my Do-more are correct and my Beijer settings are attached as a picture

Does anyone know of any other drivers that could be used to communicate to these PLC's? Any help would be appreciated
Attachments
Untitled.png
Untitled.png (42.43 KiB) Viewed 4366 times

User avatar
Chris T.
Posts: 109
Joined: Mon Nov 20, 2017 5:29 pm

Re: Do-more PLC with a iX T7A communication

Post by Chris T. »

Hi mike.b,
AutomationDirect can be tricky as they outsource the PLC manufacturing. In general you will want to refer to the "Koyo" section of our drivers and determine which of the three options there best suits your specific PLC.
Best regards,
Christopher
(801) 708-6690
Technical Support
Contact Us

Beijer Electronics AB
http://www.beijerelectronics.us

Post Reply