Redundant PLC

Discussion of configuring and troubleshooting communication to PLC's or other devices using iX Developer.
Post Reply
satyngar
Posts: 3
Joined: Tue Sep 23, 2014 7:13 am

Redundant PLC

Post by satyngar »

I have stuck on one problem. Saw similar one question on iX forum, unfortunately didn't find any answer.
The question is about redundant PLC (Siemens S400). Using manual I've configured them as you can see in attached picture. Selected S7 ISO TCP/IP protocol. In tag list connected them to different address (example:
0:DB30.DBX0.4
1:DB30.DBX0.4
to read the PLC status (Master or Stand by) . When the HMI panel (T15BR) start up, system read all data correctly, but when I switch over PLC, HMI don't update tag status, no matter which PLC is master and no matter if I turn the Master status back. HMI is not recognizing any data from PLC after such change. I would be very thankful could give me some advice.
Attachments
plc.jpg
plc.jpg (64.6 KiB) Viewed 8331 times

User avatar
Jae V
Posts: 118
Joined: Wed Jan 15, 2020 11:00 am

Re: Redundant PLC

Post by Jae V »

Hello,
We understand that this is a very old post. If there is anyone who is still experiencing this or similar issues and require assistance, please visit us at https://www.beijerelectronics.us/en-US/ ... ___support or give us call at 801.708.6690. Thank you.
Best regards,
Jason
(801) 708-6690
Technical Support
Contact Us



Beijer Electronics AB
http://www.beijerelectronics.us

Post Reply