System Tag Communication error or Message

Discussion of configuring and troubleshooting communication to PLC's or other devices using iX Developer.
Post Reply
daoa80
Posts: 44
Joined: Fri Aug 10, 2012 8:50 am

System Tag Communication error or Message

Post by daoa80 »

when disabling the messages (upper left corner) when a communication error happens, the error will not show (which is OK) but the error also dissapears from the system. There is no way to see (using labels) if the error is been generated.

any ideas?

stuartm
Posts: 61
Joined: Thu Jun 06, 2013 9:21 am

Re: System Tag Communication error or Message

Post by stuartm »

Please see this project:
Attachments
DialogAlarm.zip
(38.39 KiB) Downloaded 731 times

danielibby9
Posts: 1
Joined: Mon May 05, 2014 5:26 pm

Re: System Tag Communication error or Message

Post by danielibby9 »

I have the same question. I have a CPU that communicates with the HMI over Ethernet and another device that communicates with the HMI over RS232. My CPU has no way of knowing if I have lost communications with my RS232 device. Is there something in Script that I can use if a Comm Error is generated (even if the Comm Error is disables and is not showing as the original questioner suggests)?

Post Reply