Soft reboot when valid project detected on USB

Forum for sample programs interacting with the panel hardware.
Locked
User avatar
Kyle W.
Posts: 36
Joined: Wed Apr 09, 2014 3:16 pm

Soft reboot when valid project detected on USB

Post by Kyle W. »

This project has a thread that looks for a valid project on a connected USB. When a valid project is detected, it initiates a soft reboot when the timer reaches 100 seconds. The timer was put in to give an operator time to pull the USB out of the panel after it successfully loads. Warning: leaving the USB connected that contains a valid project will continuously reboot the panel every 100 seconds.
Attachments
UsbRebootAndLoad.zip
(840.64 KiB) Downloaded 904 times
Best Regards,

Kyle W. | Applications Engineer
Beijer Electronics, Inc.

User avatar
Chris T.
Posts: 109
Joined: Mon Nov 20, 2017 5:29 pm

Re: Soft reboot when valid project detected on USB

Post by Chris T. »

Locked
Best regards,
Christopher
(801) 708-6690
Technical Support
Contact Us

Beijer Electronics AB
http://www.beijerelectronics.us

Locked